Driven Designs Inc. PPS User Manual
Page 13
POOL PATROL PA-25 & PA-30
RECEIVER
Your receiver works with the pool alarm allowing you to monitor your pool
from within your house. When the floating alarm is activated it sends a
signal to activate the receiver.
from within your house. When the floating alarm is activated it sends a
signal to activate the receiver.
Setup
Plug in the power jack to a wall outlet and plug the other end into the
power jack connector (Figure 9). Turn power switch to “on” position, the
red LED indicator will turn on.
Plug in the power jack to a wall outlet and plug the other end into the
power jack connector (Figure 9). Turn power switch to “on” position, the
red LED indicator will turn on.
Transmission Modes
The receiver has two modes of operation: Serial Number mode (SN
mode) and ID mode. When the receiver is in SN mode it will accept the
transmission of any Pool Patrol transmitter (this is the default setting).
The serial number is common to all transmitters. When the receiver is in
ID mode it will accept the serial number plus the ID number of the
transmission. The ID number is unique to each transmitter.
The receiver has two modes of operation: Serial Number mode (SN
mode) and ID mode. When the receiver is in SN mode it will accept the
transmission of any Pool Patrol transmitter (this is the default setting).
The serial number is common to all transmitters. When the receiver is in
ID mode it will accept the serial number plus the ID number of the
transmission. The ID number is unique to each transmitter.
Mode Change
To change from SN mode (default) to ID mode or back from ID mode to
SN mode, turn off the receiver. Locate the mode button on the top left
corner of the receiver (Figure 10). Using a paper clip or tooth pick hold
To change from SN mode (default) to ID mode or back from ID mode to
SN mode, turn off the receiver. Locate the mode button on the top left
corner of the receiver (Figure 10). Using a paper clip or tooth pick hold
Power
Jack
Jack
Speaker
Indicator
LED
LED
Security
System
Connections
System
Connections
Figure 9 Receiver