Driven Designs Inc. PPS User Manual
Page 7
POOL PATROL PA-25 & PA-30
INSTALLING OR CHANGING THE BATTERY
The pool alarm requires a 9V alkaline battery. One 9V alkaline battery
will last for one year under normal use. The battery is in a compartment
under the floatation base. You will need a Philips screw driver to remove
the battery cover.
will last for one year under normal use. The battery is in a compartment
under the floatation base. You will need a Philips screw driver to remove
the battery cover.
1)
Turn
the
alarm
upside down. Note the black
floatation base and the words
“BOTTOM” and the word
“SENSITIVITY” with an arrow
to
floatation base and the words
“BOTTOM” and the word
“SENSITIVITY” with an arrow
to
“INCREASE”
or
“DECREASE” the sensitivity.
To remove the float, turn the
black flotation base in a
counter-clockwise
To remove the float, turn the
black flotation base in a
counter-clockwise
direction
or
in the “DECREASE”
direction, until the base is
loose from the upper blue
housing. Figure 1 is a picture
housing. Figure 1 is a picture
of the battery cover with the float removed.
2) Once the floatation base is
off locate the battery cover
(Figure 1). Remove the
two screws and lift off the
battery cover and gasket
exposing the 9V battery
clip.
(Figure 1). Remove the
two screws and lift off the
battery cover and gasket
exposing the 9V battery
clip.
3) Snap a 9-volt alkaline
battery on to the battery
clip
clip
(Figure
2)
and
carefully insert the 9V
battery and clip into the
battery compartment.
battery and clip into the
battery compartment.
Figure 2 Battery Clip
Figure 1 Battery Cover
IMPORTANT
Use only a 9V alkaline battery. Be careful when installing or
removing the battery as the battery clip can break.
removing the battery as the battery clip can break.