Atech OEM Inc. WM100X User Manual
iWEM-1000UM, Dec 30, 2010
Atech Technology Co., Ltd.
7F, AAEON Building, No.43, Sec. 4, Keelung Rd, Taipei City 10607, Taiwan (R.O.C.)
Tel: +886-2-2377-0282
Fax: +886-2-2377-0283
http://www.atechoem.com/
Action Commands – Perform action such as scan, connect, disconnect, etc.
Config Commands – Set the iWEM-1000 configuration. The user needs to issue a save command to
Config Commands – Set the iWEM-1000 configuration. The user needs to issue a save command to
save the updated configuration to the flash memory. The new configuration will take effect after reboot.
Status Commands – See what is going on with the interface, IP status, etc.
The user can issue ? command to list all available commands. All available commands will be printed to the
terminal emulator in ascii format.
All commands issued to iWEM-1000 must be followed by <CR> character as a command terminator.
4.3. Action Commands
The action commands are the commands to have the iWEM-1000 doing various actions other than changing
the configuration of the module.
Command
Response
Action and Notes
exit Data
mode<CR>
Exit command mode
ls
<List of files><CR>
List all files in flash
scan [<ssid>]
<List of APs><CR>
Scan for infrastructure BSSs to join
ping
<ping_IP_addr>
<ping response from
the pinged
host><CR>
Send an ICMP echo request to the specified IP address.
Ping the default gateway if no IP_address is specified
set_factory_defaults OK<CR>
Restore the configuration to factory default settings. The
settings take effect after the module is restarted.
tcp_connect TCP
Connecting...
<CR>
Create a connection to the TCP server
tcp_disconnect TCP
Disconnected<CR>
Drop the TCP connection. If the setting is TCP server,
disconnect the TCP client connected to iWEM-1000. If the
setting is TCP client, disconnect from the TCP server.
restart OK:
Restarting
application
now<CR>
Restart the current application
save OK<CR>
Save the configuration to the EEPROM memory. The
settings take effect after the module is restarted.
sleep Power
down...<CR>
Put iWEM-1000 module into sleep mode. Ground pin 5 to
wake up module.
tftp_get
<tftp_server>
OK<CR>
Get a image from the TFTP server to upgrade firmware.