Atech OEM Inc. WM100X User Manual
iWEM-1000UM, Dec 30, 2010
Atech Technology Co., Ltd.
7F, AAEON Building, No.43, Sec. 4, Keelung Rd, Taipei City 10607, Taiwan (R.O.C.)
Tel: +886-2-2377-0282
Fax: +886-2-2377-0283
http://www.atechoem.com/
<file_name>
boot_image
<handle>
<file_name>
OK<CR>
Set the boot image. The settings take effect after the
module is restarted.
4.4. Config Commands
Config commands are to set different types of parameters in iWEM-1000. The typical response of a Config
command is OK<CR>. The user must issue save<CR> to store the updated configurations into the flash
memory. The new configuration will take effect after reboot.
4.4.1. WLAN
WLAN commands are for the users to configure the WLAN interface. The WLAN parameters can be set
with the WLAN commands.
Command
Response
Action and Notes
set_antenna <ant#> OK<CR>
Select antenna configuration:
Ant# = 0, antenna used = UFL or SMA connector.
Ant# = 1, antenna used = chip antenna.
Default = 0
set_ssid
<ssid_string>
OK<CR>
Set the SSID of the BSSID with which we'll associate
Default = Atech
set_channel
<channel>
OK<CR>
Set the 802.11b/g channel to use.
channel = 1 to 13.
Default = 1
set_wlan_mode
<wlan_mode>
OK<CR>
Set WLAN mode, 0:Infrastructure, 1:Ad-Hoc
wlan_mode = 0:Infrastructure, 1:Ad-Hoc
Default = 0
set_preferred_rates
<r1> <r2> <r3> <r4>
OK<CR>
Set the 802.11b/g channel to use.
r1, r2, r3, r4 = {54, 48, 36, 24, 12, 6, 11, 5, 2, 1}
Default = 24 12 5 1
The four data rate set should be a descendant series or
equal numbers. The rates must be selected from the
defined set shown above.
set_passwd wep40
<key#> <password>
set_passwd wep40
<key#> <password>
Select WEP40 key number, and set WEP keys.
key# = 1 to 4.
password = xx xx xx xx xx; x=0 to f.