RadioFrame Networks Inc DH2 User Manual

RadioFrame System 

RFN_3.1 Beta

mounting this unit in any fashion not recommended and approved by 
RadioFrame Networks. This includes, but is not limited to, damage to, or loss of, 
equipment, loss of data, or loss of profit, even if RadioFrame Networks was 
advised of the possibility of such damages 

1  Place the 11” x 17” drawing template (P/N 981-1020-00) on the wall where 

the RadioFrame Unit is to be mounted. 

2  Mark the two locations indicated on the template. 

3  Screw the two supplied anchors into the locations as shown in the following 

diagram. 

4  Screw the two supplied screws into the anchors, leaving approximately 1/4” 

of each screw exposed. 

5  Hang the RFU on the anchors and fully tighten both screws. 

 

A wall mount requires two screws to anchor the RFU.  

1  Place the 8.5” x 11” drawing template (P/N 981-1010-00) on the ceiling where 

the RFU is to be mounted. 

2  Mark the four locations indicated on the template. 

3  Drill four holes with the appropriately sized bit: 3/16” for the provided wood 

screws, or 9/32” for 1/4” bolts (bolts not provided). 

If using the provided wood screws, ensure that all four screws penetrate 
wood. Otherwise, use alternative mounting screws or bolts to secure the 
ceiling bracket.