RadioFrame Networks Inc MCSERIES10 User Manual
MC-Series System Installation & Testing
System Configuration Changes
RadioFrame Networks, Inc.
105
respective status LEDs. Reinsert the RBS. To do this, press up on one side rail locking
arm and press down on the other side rail locking arm, and then push the unit into the
rack (see the following illustration).
arm and press down on the other side rail locking arm, and then push the unit into the
rack (see the following illustration).
•
BIC CRIC and AIC CRIC: The POWER and STATUS LEDs will light red and then green.
All other BIC and AIC card LEDs will light green.
All other BIC and AIC card LEDs will light green.
14
Using the breaker on the PDU, turn up RF Shelf 1 and RF Shelf 2.
Do not turn up RF Shelf 3. Verify that RF Shelf 1 and RF Shelf 2 are operational before
proceeding.
Do not turn up RF Shelf 3. Verify that RF Shelf 1 and RF Shelf 2 are operational before
proceeding.
The POWER and ALARM LEDs on the front of each RF shelf will light green.
15
Complete the procedure in section 7.8 TOR Tx Measurement Procedure.
8.4 Removing a Sector
To remove a sector from the MC-Series System, disconnect an RF shelf. To remove one sector,
disconnect RF Shelf 3. To remove two sectors, disconnect both RF Shelf 2 and RF Shelf 3. Refer
to Appendix C Cabling Diagrams: 3-Sector Configuration.
disconnect RF Shelf 3. To remove two sectors, disconnect both RF Shelf 2 and RF Shelf 3. Refer
to Appendix C Cabling Diagrams: 3-Sector Configuration.
1
Have the site configuration available.
2
In System Manager, display the iDEN Configuration page, and change the cabinets and
positions (and quad BRs or adjacent channel assignments) as required for the new
configuration (refer to the site datafill).
positions (and quad BRs or adjacent channel assignments) as required for the new
configuration (refer to the site datafill).
3
Power down all RFN equipment in the following order using circuit breakers on the PDU:
•
BIC
•
AIC
•
RBS 1 (RBS 2 and RBS 3 if present)
•
RF shelf 1, 2, and 3
4
Remove the following terminations from RF Shelf 1:
•
RF Shelf 2: Tx IN B and Rx OUT B
•
RF Shelf 3: Tx IN C and Rx OUT C
5
Reconnect terminations to:
•
RF Shelf 2: Tx IN B and Rx OUT B
•
RF Shelf 3: Tx IN C and Rx OUT C
6
Reconnect the following RF cables to RF Shelf 1:
Index
Part Number
From
To
Type
RF_2
820-0611-20
RF Shelf 2: Tx IN B
RF Shelf 1: Tx IN B
RF cable
RF_5
820-0611-20
RF Shelf 2: Rx OUT B
RF Shelf 1: Rx OUT B
RF cable
RF_3
820-0611-20
RF Shelf 3: Tx IN C
RF Shelf 1: Tx IN C
RF cable
RF_6
820-0611-20
RF Shelf 3: Rx OUT C
RF Shelf 1: Rx OUT C
RF cable