Schulte-Schlagbaum AG SOT02 User Manual
SAG
SAFE-O-TRONIC
Installation
Schulte- Schlagbaum AG
Page 11 of 14
SOT-manual.DOC
7. Battery
The battery in the SAFE-O-TRONIC is designed for at least 40 actuations daily within a period of 3
years. The time when the battery needs to be replaced will depend however on the self-discharging
of the battery and by climatic effects, especially cold temperatures.
years. The time when the battery needs to be replaced will depend however on the self-discharging
of the battery and by climatic effects, especially cold temperatures.
To summarize, the time to replace the battery depends on the following factors:
1. the number of actuations,
2. how long the battery has been installed, and
3. the ambient temperature in which the SAFE-O-TRONIC is operated.
7.1. Battery replacement
The battery compartment integrated into the lock body is only accessible when the cabinet is
opened, and can only be opened using a special screwdriver (Type:
opened, and can only be opened using a special screwdriver (Type:
ID ML.SSD-A)
.
•
After opening the battery compartment, disconnect the discharged battery pack at the connector
and plug in the new battery pack.
•
Once the new battery pack has been installed, the SAFE-O-TRONIC is ready for immediate
use. Use the ClockSetKey to set the internal real time clock after the battery was replaced or
disconnected.
disconnected.
•
The discharged battery pack must be properly disposed of according to prevailing envi-
ronmental regulations!
NOTE:
•
The discharged battery pack must be properly disposed of according to prevail-
ing environmental regulations!
ing environmental regulations!
•
Use only batteries recommended by the manufacturer (Type: ID ML.BP-A). The
use of non-approved batteries may cause malfunctions and result in damage to
the SAFE-O-TRONIC.
use of non-approved batteries may cause malfunctions and result in damage to
the SAFE-O-TRONIC.
8. Service / Maintenance
The mechanical parts of the SAFE-O-TRONIC are maintenance-free. Under no circum-
stances use mineral oil based lubricants or greases.
stances use mineral oil based lubricants or greases.
Clean only using non-sticky, non-residue cleaners and disinfectants. Do not use harsh sol-
vents, acids or lye for cleaning.
vents, acids or lye for cleaning.
NOTE:
Cleaning with water-jet or steam jet could occur irreparable damage!
Cleaning with water-jet or steam jet could occur irreparable damage!