Tagsys S.A. WIFILIBINVREAD User Manual
WiFi Inventory Reader
4.2.1 Default Reader Network Settings
You will not be able to configure any network setting before the reader is not engaged with your
access point.
access point.
You need first to setup your access point in order to establish the wireless connection with the WiFi
Inventory Reader.
Inventory Reader.
The mandatory information you need are the following:
-
The reader is compliant with IEEE 802.11b. Please check your access point is able to
support this standard (access point configuration “b or g” or “b only”)
support this standard (access point configuration “b or g” or “b only”)
-
SSID of the reader is TAGSYSRFID and the access point must be set accordingly
-
No encryption is used to communicate with the reader
The SSID and the Encryption status can be changed afterward.
Additionally, the default settings for the reader network configuration are:
- DHCP
:
Off
-
Static IP Address : 192.168.0.2
-
Subnet Mask : 255.255.255.0
-
Default Gateway : 0.0.0.0
-
SSID : TAGSYSRFID
-
Available to any wireless network
-
Country : United States
-
Channel : Auto-scan
-
Network Authentication : Open System
-
Data Encryption : Open System
Once the access point has been configured, power up the WiFi Inventory Reader and check the
network link indicator as showed in the picture below. This indicator blinks during the initialization
and stays on once a connection has been established with the WiFi access point.
network link indicator as showed in the picture below. This indicator blinks during the initialization
and stays on once a connection has been established with the WiFi access point.
Figure 4: Network link indicator
Once the first connection has been established using the default factory network parameters, you
can now modify the network parameters of the WiFi Inventory Reader
can now modify the network parameters of the WiFi Inventory Reader
16/36
Revision 1.1c
June 2007