Hunter Industries Inc SSW User Manual

1... Connect.the.red wire.from.the.Solar.Sync.module.to.the.AC1.terminal
2... Connect.the.white wire.from.the.Solar.Sync.module.to.the.AC2.terminal
3... Connect.the.blue wire.from.the.Solar.Sync.module.to.the.REM.terminal
4... remove.the.flat.metal.jumper.from.the.two.SEN.terminals.
5.. Connect.the.yellow wire.to.one.of.the.SEN.terminals
6... Connect.the.orange wire.to.the.other.SEN.terminal

Mount.the.Wireless.Receiver.on.the.controller.cabinet.using.an.available.knock.out.and.secure.with.the.supplied.conduit.nut,.similar.to.the.

Pro-C.installation.shown.on.page.8..Or,.use.the.supplied.brackets.to.mount.the.Wireless.Receiver.on.the.wall..Depending.on.the.installation,.

the.supplied.1.5".(3.8.cm).extender.may.be.required..Route.the.wires.from.the.Wireless.Receiver.in.to.the.controller.cabinet.
1.. Make.sure.power.to.the.controller.is.turned.off
2... Connect.the.black.Receiver.wire.to.the.black.Module.wire
3... Connect.the.green.Receiver.wire.to.the.green.Module.wire.
4.. Initialize.communication.by.following.steps.outlined.in.“Addressing.Wireless.Receiver/Sensor”.section.on.page.13

Blue

Orange

Yellow

White
Red

®