Data Critical Corporation AVTS1010 User Manual
AlarmView™ System User’s Guide
{insert part #} Page 18
{Insert photo of power supply and AC power cord}
Power Supply with Hospital-grade AC Power Cord
!
!
!
Although transmitter can operate on its internal backup battery for a
short period of time (up to 45 minutes under normal operation),
always use AC power when possible.
Do not connect transmitter to an electrical outlet controlled by a wall
switch. If power is accidentally turned off, transmitter will run on
backup battery. Backup battery will only support normal operation for
45 minutes or less.
short period of time (up to 45 minutes under normal operation),
always use AC power when possible.
Do not connect transmitter to an electrical outlet controlled by a wall
switch. If power is accidentally turned off, transmitter will run on
backup battery. Backup battery will only support normal operation for
45 minutes or less.
Connect to Monitor
1. Connect modular RJ-45 plug end of interface cable to
monitor input port on rear panel of transmitter.
{Insert monitor input port (Figure 7)}
Monitor Input Port
2. Connect pin connector end of interface cable to data port on
rear of monitor.
A serial cable with a 15-pin (Male DB15) connector is
required to connect to NPB-290, NPB-295, and N-395
monitors. A serial cable with a 7-pin (male 7 pin DIN)
connector is required to connect to N-3000 monitor.
A serial cable with a 15-pin (Male DB15) connector is
required to connect to NPB-290, NPB-295, and N-395
monitors. A serial cable with a 7-pin (male 7 pin DIN)
connector is required to connect to N-3000 monitor.
{Insert monitor data port for N-395, same as NPB-290 and NPB-295
(Figure 8)}
NPB-290, NPB-295, and N-395 Monitor Data Port
{Insert monitor data port for N-3000 (Figure 9)}
N-3000 Monitor Data Port