Data Critical Corporation AVTS1010 User Manual
AlarmView™ System User’s Guide
{insert part #} Page 21
programming will be lost, and data will need to be reprogrammed
into transmitter.
into transmitter.
3. Mode LED is solid green when transmitter has established
communication with monitor.
Tx LED will flash green, and transmitter will send a Comm
OK Page to assigned pager(s) to confirm communication
between transmitter and monitor. The message will display:
Tx LED will flash green, and transmitter will send a Comm
OK Page to assigned pager(s) to confirm communication
between transmitter and monitor. The message will display:
Bed: 1234
Comm OK
All Pagers*
Comm OK
All Pagers*
*Last line All Pagers with be replaced with “Pager 1234” if one pager is
assigned to transmitter, and “Pager 1234 5678.” The 4 digits correspond
to the last 4 digits of the assigned pager(s)’ cap code.
4. Verify that page is sent to assigned pager(s) and that bed
number is correct.
The transmitter will now send pages to the assigned pager(s)
whenever it detects alarms identified by the monitor.
whenever it detects alarms identified by the monitor.
Turning Transmitter Off
The transmitter can be turned off only when it is not
communicating with the monitor. To turn the transmitter off:
1. Turn monitor off or disconnect interface cable from
communicating with the monitor. To turn the transmitter off:
1. Turn monitor off or disconnect interface cable from
transmitter or monitor. Mode LED will be Amber.
2. Press On/Off button. Mode LED will be Off.
!
!
!
!
!
!
If you disable communications between the transmitter and
monitor and do not turn off the transmitter, the transmitter will
monitor and do not turn off the transmitter, the transmitter will