Data Critical Corporation AVTS1010 User Manual
AlarmView™ System User’s Guide
{insert part #} Page 43
reestablish
communication.
communication.
AC power.
Check monitor
performance.
Check monitor
performance.
Comm
Failure/Shutting Down
Transmitter has not
been able to
communicate with the
monitor for about an
hour and is shutting
down.
Failure/Shutting Down
Transmitter has not
been able to
communicate with the
monitor for about an
hour and is shutting
down.
Communications
between transmitter
and monitor have
failed.
Monitor is turned off or
operating on battery
power and transmitter
is still on.
between transmitter
and monitor have
failed.
Monitor is turned off or
operating on battery
power and transmitter
is still on.
Check serial cable
and cable connections
between transmitter
and monitor.
Reconnect or replace
cable as required.
Connect monitor to
AC power.
Check monitor
performance.
and cable connections
between transmitter
and monitor.
Reconnect or replace
cable as required.
Connect monitor to
AC power.
Check monitor
performance.
The programmer may also display error messages related to its function.
Below is a table of Programmer Error Messages, along with probable
causes, and recommended corrective actions.
Programmer Error Messages
Message
Possible Cause
Corrective Action
Failed to Connect
Programmer was
unable to retrieve or
send information
to/from transmitter.
Programmer was
unable to retrieve or
send information
to/from transmitter.
Programmer infrared
port not aligned with
transmitter infrared
port.
Transmitter turned off.
Programmer batteries
are low.
Transmitter defective.
Programmer
defective.
port not aligned with
transmitter infrared
port.
Transmitter turned off.
Programmer batteries
are low.
Transmitter defective.
Programmer
defective.
Re-align ports and try
again.
Turn on transmitter.
Recharge programmer
batteries.
Contact Data Critical
Corp. regarding repair
and/or replacement of
transmitter or
programmer.
again.
Turn on transmitter.
Recharge programmer
batteries.
Contact Data Critical
Corp. regarding repair
and/or replacement of
transmitter or
programmer.