JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 6
Using the RapidCall™ Vibration/Tone Pagers
Battery Installation
Slide the battery door latch in the direction of the arrow on the pager (Fig. 2.)
Slide the battery door down from the top to open. Insert one AA alkaline battery,
observing the proper polarity. Replace the battery door and lock into place.
Slide the battery door latch in the direction of the arrow on the pager (Fig. 2.)
Slide the battery door down from the top to open. Insert one AA alkaline battery,
observing the proper polarity. Replace the battery door and lock into place.
Fig. 2 – RapidCall Pager (rear)
Fig. 3 – RapidCall Pager (front)
Low Battery Indicator
The light located on the top of the RapidCall pager will flash red and the pager
will emit a short beep, indicating the battery is low (Fig.3.) If the green light
flashes every five seconds, the battery is OK. If no light is present, the battery is
dead and needs to be replaced.
RapidCall Pager Operation
1. The RapidCall vibration/tone pager is simple to operate, featuring a single
button design (Fig. 3.) To turn on the pager, press firmly and hold the button
on the side of the pager for approximately five (5) seconds. Installing the
battery will also turn the pager on. When activated, the pager will vibe and
tone for three (3) seconds, indicating the start up self-test is complete. Once
“on,” the light located on the top of the pager will flash green every five (5)
seconds to indicate the pager is on. To page a RapidCall pager from the
Desktop Transmitter keypad, type the pager number followed by the # key.
on the side of the pager for approximately five (5) seconds. Installing the
battery will also turn the pager on. When activated, the pager will vibe and
tone for three (3) seconds, indicating the start up self-test is complete. Once
“on,” the light located on the top of the pager will flash green every five (5)
seconds to indicate the pager is on. To page a RapidCall pager from the
Desktop Transmitter keypad, type the pager number followed by the # key.