JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 7
2. To page the RapidCall vibration/tone pager pre-programmed with the multiple
vibration option from the master transmitter keypad, type
1 vibration = 1xxx#
2 vibration = 2xxx#
3 vibration = 3xxx#
2 vibration = 2xxx#
3 vibration = 3xxx#
(where x represents the pager id ; in instances where the pager id number is less than 3-
digits the leading x is replaced with a zero (0))
digits the leading x is replaced with a zero (0))
Example: Send 2 vibe alert to pager id 1 = 2001#
Send 3 vibe alert to pager id 2 = 3002#
Send 2 vibe alert to pager id 12 = 2012#
Send 3 vibe alert to pager id 224 = 3224#
3. To page a RapidCall pager from the telephone interface on the PeopleAlert
2601,
pick up the receiver, listen for the dial tone, and dial the system
extension or analog phone line number that has been assigned to the Paging
System. The line will ring until the unit answers, at which point the Out-of-
Range (OOR) signaling is temporarily de-activated. When connected (a beep
indicates the system is ready for you to enter the pager number) press the
number of the pager (up to four digits) you wish to page, using the telephone
keypad, and press the # key to send the vibration/tone page. The same
option to page with multiple vibrations is available from the telephone
interface by dialing into the assigned extension and following the instructions
noted above.
System. The line will ring until the unit answers, at which point the Out-of-
Range (OOR) signaling is temporarily de-activated. When connected (a beep
indicates the system is ready for you to enter the pager number) press the
number of the pager (up to four digits) you wish to page, using the telephone
keypad, and press the # key to send the vibration/tone page. The same
option to page with multiple vibrations is available from the telephone
interface by dialing into the assigned extension and following the instructions
noted above.
Once “on,” RapidCall vibration pagers can only be turned off by sending the
appropriate transmission from the Desktop transmitter. This over-the-air (OTA)
transmission sends a sleep message to ALL RapidCall vibration pagers. To shut
off RapidCall Vibe/Tone pagers with the OTA command, type 9991 # from the
transmitter keypad. All pagers will respond with a short vibe-tone-flash.
Receiving Pages
When a page is received, the RapidCall pager will alert depending on how it has
been ordered and subsequently programmed:
• Vibe only pager: 4 seconds of vibration with a solid green LED
• Tone only pager: 4 seconds alternating beeps and flashing green LED
• Vibe and tone pager: 4 seconds alternating vibration, beep, and flashing
green LED
Press the button on the side of the pager to stop the alert or wait until the alert
stops by itself. The pager is now ready to receive the next page.