JTECH Communications Inc. SERIES2600 User Manual
JTECH UHF Desktop Transmitter Installation and Operation Guide 320115K
Page 13
Receiving Pages
To page a Glowster pager, type the pager number followed by the # key on the
master transmitter keypad. The pager will respond with the default alert that has
been programmed into the master transmitter. The factory default is Alert 3.
To page a Glowster pager, type the pager number followed by the # key on the
master transmitter keypad. The pager will respond with the default alert that has
been programmed into the master transmitter. The factory default is Alert 3.
Ex.
If “Default # Vibes ?” on the transmitter has been set to “3” the
pager will respond with three (3) 15 second alert cycles for a total
45 second page alert.
pager will respond with three (3) 15 second alert cycles for a total
45 second page alert.
You can also send an individual alert that is different from the default by entering
a “0” before the pager number and enter the alert number after the “#”. (See
Table 1 on page 16 for complete alert definitions.)
a “0” before the pager number and enter the alert number after the “#”. (See
Table 1 on page 16 for complete alert definitions.)
Ex.
Send a fifteen (15) minute alert (alert 5) to pager #12.
On the master transmitter keypad type in “0 1 2 # 5”. (This
particular feature is also referred to as “long page”.)
On the master transmitter keypad type in “0 1 2 # 5”. (This
particular feature is also referred to as “long page”.)
Optional “Tone” Glowster
An optional version of the Glowster pager includes Tone alerts, providing 3 short
bursts of a double tone alert prior to the standard vibration and flash alerts.
Should Tone Glowster be ordered, and it be subsequently decided that the tone
is undesirable, the tone can be deactivated from the transmitter by sending the
“Audible OFF” transmission. This command can be activated by pressing 9995#
from the transmitter keypad. It is essential that all Glowster pagers be off the
charging rack and not stacked to be able to “hear” the “Audible OFF” command.
Standard Glowster Alerts
Alert 1 – Vibe, and Flash for 1 15-second cycle.
Alert 2 – Vibe, and Flash for 2 15-second cycles (30 Sec.)
Alert 3 – Vibe, and Flash for 3 15-second cycles (45 Sec.)
Alert 4 – Vibe, and Flash for 4 15-second cycles (60 Sec.)
Alert 5 – Vibe, and Flash for 60 15-second cycles (15 Minutes)
Alert 2 – Vibe, and Flash for 2 15-second cycles (30 Sec.)
Alert 3 – Vibe, and Flash for 3 15-second cycles (45 Sec.)
Alert 4 – Vibe, and Flash for 4 15-second cycles (60 Sec.)
Alert 5 – Vibe, and Flash for 60 15-second cycles (15 Minutes)
All standard Glowster alerts are preceded by the pulse tones with the Tone
Glowster pager. Again, the factory default setting is Alert 3.
Glowster pager. Again, the factory default setting is Alert 3.