JTECH Communications Inc. SERIES2600 User Manual

 

             Page 25 

 

1.  Pick up the receiver, listen for the dial tone, and dial the system extension 

that has been assigned to the Paging System.  A beep indicates the system is 
ready for you to enter the pager number. 

2.  Within 20 seconds, press the number of the pager (up to four digits) you wish 

to page, using the telephone keypad.  

3.  For a RapidCall vibe/tone or Glowster only pager, press the # key next to 

send the vibration/tone or Glowster page.  For a numeric page, enter the 
pager number up to four digits followed by the * key, and then enter an 
optional message up to 16 digits followed by the # key.  A beep is heard 
verifying the message was sent.  If the numeric message is exactly 16 digits, 
a beep is heard once the 16th digit is entered.   

4.  Hang up the receiver. 

1.  Pick up the receiver, listen for the dial tone, and dial any of the system 

extensions that have been assigned to the Paging System.  You will hear a 
single beep indicating the system is ready for you to enter the group number. 

2.  Within 20 seconds press the * key followed by the number of the group (1-99) 

you wish to page using the telephone keypad.  

3.  Press the * key again to continue with a numeric message or press the # key 

to transmit without a message. 

4.  Enter an optional message of up to 16 digits.  If the message is less than 16 

characters, press the # key on the phone keypad to indicate the end of the 
message and send the page.  A beep is heard verifying the message was 
sent.  If the message is exactly 16 digits, a beep is heard once the 16th digit 
is entered.    

5.  Hang up the receiver.