JTECH Communications Inc. SERIES2600 User Manual

 

             Page 26 

 
Function Menu Descriptions 
The following table lists the special functions available from the transmitter 
keypad with the Desktop Transmitters.  (Many functions are accessible from the 
telephone interconnect although some are not.)  From the transmitter keypad, 
press the * key to scroll down through the features menu.  Follow the instructions 
shown below to activate a special feature.  To return to the paging mode, scroll to 
the end of the special function menu and the unit will automatically return to the 
paging mode.  In summary: Press * to scroll down the menu, Press # to enter a 
function, Press 0 to scroll up through functions if not past the ‘Active Groups’. 

 

Replace Pager 
   Scroll Down * 
   Scroll Up 0 
   Enter Function # 
 
 
 
 
 
 
(Return a Pager to 
the original Pager 
ID) 

Logically replaces pagers.   Input the old pager number (1 to 4 
digits), #, the new pager number (1 to 4 digits), #, and the kind 
of pager (2 pages of options, press # to get to the second 
page.  Pager type selection is done by entering a 1, 2, 3, or 4 
from the screen; touch # to scroll to screen 2).  To repeat the 
replace pager operation, press # again.  Up to 500 old pagers 
may be replaced.  After the Replace Pager entry, the new 
pager will be paged when the old pager number is entered.  
To remove an entry in the replace table and return the pager to 
its original pager ID, enter the original pager number as the old 
pager number and enter zero for the new pager number.  A 
confirmation message will say that the Original pager number 
has been removed. 

Display Pager 
   Scroll Down * 
   Scroll Up 0 
   Enter Function # 

Displays all pagers that have been replaced.   The # key takes 
you forward to the next entry; zero takes you back to the 
previous entry.  Exit the function by pressing the * key at any 
time. 

Add Pager to 
Dynamic Group 
   Scroll Down * 
   Scroll Up 0 
   Enter Function # 

There are 99 Dynamic Groups that can be programmed.  The 
first 9 (1 – 9) are transmitted with any factory pre-programmed 
groups with the same number.  To build a group of pagers that 
will be paged in rapid succession (Dynamic Group), press # at 
this menu item.  When asked ‘Which Group’, enter a one or 
two digit group number.   When asked ‘Which pager’ enter the 
last pager on the group list (Dynamic groups are paged in the 
reverse order of entry).   The pager type must be selected by 
entering 1, 2, 3, or 4, which identifies the pager as POC, 
Glwstr, NUM, or ALP (alpha).  Press # after this entry to enter 
another pager in the same dynamic group.  Press * when the 
last entry has been made.  Up to 500 pagers may be entered in 
dynamic groups.  Pagers entered in dynamic groups will be 
replaced if they are entered in the replace pager table.  As 
Dynamic Groups are built, users should ideally create each 
pager groups to consist of 10-12 pagers so that the 
transmission period does not tie up the transmitter.  Groups 
can consist of a mixture of pager types.  The transmitter cannot 
be used for other pages while transmitting pages from the 
dynamic group are being sent.