Senstar Corporation E7BA0300 User Manual

Installation

Rev A

Page 4

FlexZone Wireless Gate Sensor

1.

Remove and retain the mounting hardware from the 2 standoffs on the FlexZone processor 
(flat washer, lock washer, machine screw).

2.

Align the 20-pin header on the bottom of the receiver with the expansion header on the 
FlexZone processor and align the 2 mounting holes on the receiver with the 2 standoffs. 
Carefully, insert the receiver into the expansion header. Use the retained mounting hardware 
to secure the receiver to the FlexZone processor.

3.

Connect the antenna to the receiver (see 

1.

Remove and retain the mounting hardware securing the NIC to the processor (flat washer, 
lock washer, machine screw).

2.

Secure the NIC to the FlexZone processor with the 2 supplied standoffs.

3.

Align the 20-pin header on the bottom of the receiver with the expansion header on the NIC 
and align the 2 mounting holes on the receiver with the 2 standoffs on the NIC. Carefully, insert 
the receiver into the expansion header. Use the retained mounting hardware to secure the 
receiver to the NIC.

4.

Connect the antenna to the receiver (see 

). 

The FlexZone processor, network interface card and receiver all contain 
static sensitive components. Follow proper ESD handling procedures when 
working on the cards.
Disconnect all sources of power to the FlexZone processor before installing 
the receiver.

Figure 3 Mounting the receiver on the FlexZone processor

Figure 4 Mounting the receiver on the NIC (steps 1 & 2)