Senstar Corporation LM100 User Manual
Fence structures
Page 16
Senstar LM100 Product Guide
Barbed wire
Barbed wire outriggers must be secure to prevent movement due to environmental conditions.
Each barbed wire strand should be taut and tightly secured at each support. Any extension arms
or outriggers attached to post tops should have a tight press-fit or be spot-welded. Fasten and
secure any loose components.
Each barbed wire strand should be taut and tightly secured at each support. Any extension arms
or outriggers attached to post tops should have a tight press-fit or be spot-welded. Fasten and
secure any loose components.
Razor ribbon
The razor ribbon must be secured so that it does not move in the wind. Use bracing wires to
secure the coil and to prevent the razor ribbon from separating if it is cut (see
secure the coil and to prevent the razor ribbon from separating if it is cut (see
).
Gates
There are generally two types of gates used with fences, swinging gates and sliding gates. The
type of gate protection required is determined by:
•
type of gate protection required is determined by:
•
the type of gate
•
the frequency of gate use
•
when the system is active
Gates should consist of fence fabric on a rigid frame that includes horizontal and vertical bracing.
Figure 6: Avoiding contact with barbed wire
Figure 7: Razor ribbon
to avoid contact with the barbed wire
lower the luminaires mounting height
razor ribbon
bracing wire
wire tie