Davis Instruments DWW765Y User Manual

20

Note: 

See the Vantage Pro2 console manual for more information on the screens in the Setup Mode if 
necessary.

To verify that setup was successful, in the console’s current mode:

1. View the transmitter information displaying at the bottom of the console screen. 

If the transmitter ID being repeated is displayed and an “X” displays in the bottom 
right-hand corner of the ticker tape, the transmitter is being repeated and received by 
the console successfully.

Location considerations for every wireless repeater in the network follow the same con-
siderations that a single repeater installation follows. See “Choosing a Location” on 
page 11 for mounting considerations and limitations.

After a suitable location has been chosen it is very important to test reception between the 
stations, repeaters, and a console or Envoy before permanently mounding the repeater.

1. Hold the repeater in the desired installation location.

2. Place the repeater back in test mode if test mode has been turned off. If the repeater 

LEDs blink the normal light pattern, the repeater is successfully receiving a signal 
from the station.

3. Repeat the process for every repeater in the network.

4. In the console’s Current Weather Mode, view the station ID numbers displaying in the 

bottom of the screen. If the station IDs displaying are the stations transmitting through 
a network of repeaters, the console is successfully receiving a signals from the wire-
less repeaters and stations.