Digital Security Controls Ltd. 005132XS433 User Manual

5

For wireless keys to work on the system, you need to enroll them and then program
the function buttons. Wireless keys are not assigned to zones and require no zone
programming. You can enroll up to 16 wireless keys on the system.

Enroll Wireless keys
1. At a system keypad, enter [

✱][8][Installer’s code] to go to the Installer

Programming section.

2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to assign the wireless key a slot. These

numbers correspond to wireless key numbers 01-16.

4. Enter the key’s ESN. The entry 

must be six digits. If an older key with a 5-

digit ESN is being enrolled, add the digit [0] to the beginning of the ESN.
(E.g., if ESN=61234, enter 061234)

5. The key is now enrolled on the system. Record the serial number and the

assigned slot number in the programming worksheets in the back of this
manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.
7. (((((PC5020/

PC5020/

PC5020/

PC5020/

PC5020/PC501

PC501

PC501

PC501

PC501X

X

X

X

X only)

 only)

 only)

 only)

 only) By default, all wireless keys are assigned to

Partition 1. To assign keys to Partition 2, enable the appropriate options in
programming sections [91] and [92].

NOTE: A wireless key can only be assigned to one partition.

8. To exit press [#].

Program the Wireless Key Function Buttons
WLS909-433/WLS919-433 wireless keys have four programmable function buttons.
You must program a set of four functions for the buttons before any keys will work.
After the functions are programmed, when you press and hold one of the four buttons
for two seconds, the system will execute the programmed function.

For systems not using partitions: program the function buttons in section [59].
All wireless keys will have the same four functions.

For systems using 2 partitions (PC5020/PC501X only): all wireless keys as-
signed to Partition 1 will have the four functions programmed in section [59]. All
wireless keys assigned to Partition 2 will have the four functions programmed in
section [60]. For example, if function button 1 in Section [59] is programmed for
Stay arming, then pressing the first button on wireless keys assigned to Partition 1
will Stay arm Partition 1.

NOTE: Wireless keys will not work when the partition they are assigned to is being
accessed for zone bypassing or programming.

1. At a system keypad, enter [

✱][8][Installer’s code].

2. Enter programming section [804].
3. Enter programming section [59] for keys assigned to partition 1, or [60] for

keys assigned to partition 2.

4. For each of the 4 function buttons, enter the 2-digit number of the function

you want to select. See the programming worksheets in the back of this
manual for a list of function key options.