Digital Security Controls Ltd. 05RF5501NA User Manual

10

5. The device is now enrolled on the system. Record the serial number and the assigned

zone number in the programming worksheets in the back of this manual.

6. Continue with steps 3 - 5 until you have enrolled all wireless devices.

7. To exit press [#].

NOTE: The devices will not work properly until you complete zone and partition program-
ming (see section 4).

An electronic serial number (ESN) is printed on the back of each wireless key. ESNs are
used to enroll the wireless keys with the RF5501-433 receiver.

In order to reduce the occurrence of wireless keys with the same serial number, 6-digit
serial numbers are now printed on the back of each wireless key. The 6-digit serial numbers
include hexadecimal digits. For instructions on programming hexadecimal numbers, see
your system 

Installation Manual, Section 4: How to Program.

NOTE: 6-digit serial numbers are only supported on the following control panels: PC5020,
P-8+, PC501X v2.0 & higher, P832/DL v2.0 and higher, PC1555(MX), P-6B(MX), PC580/585
and P-48.

When connecting the RF5501-433 to a PC5010 v1.x or P-832 v1.x panel, enter 5-digit
serial numbers only. When connecting the RF5501-433 to a PC5020, P-8+, PC5015 v2.x
and higher, P832DL v2.x and higher, PC5010 v2.0 and higher, P832 v2.0 and higher,
PC1555(MX), P-6B(MX), PC580/585 or P-48 panel enter the 6-digit serial number.

For wireless keys to work on the system, you need to enroll them and then program the
function buttons, if the default values are not the functions desired. Wireless keys are
not assigned to zones and require no zone programming. You can enroll up to 16
wireless keys on the system.

1. Enter [

✱][8][Installer’s Code] to go to the installer’s programming section.

2. Enter programming section [804].

3. Enter a 2-digit number [41]-[56] to program the wireless key serial number. These

numbers correspond to wireless key numbers 01- 16.

4. Enter the key’s ESN. The entry 

must be six digits.

5. The key is now enrolled on the system. Record the serial number and the assigned slot

number in the programming worksheets in the back of this manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.

7. (PC5020/P-8+/PC501X/P832/P832DL only) By default, all wireless keys are assigned

to Partition 1. To assign keys to different partition, see programming section [69].

NOTE: A wireless key can only be assigned to one partition.

8. To exit press [#].

E N R O L L  &  P R O G R A M  D E V I C E S