Digital Security Controls Ltd. 06GS30551 User Manual
11
Telephone numbers to call
Four telephone numbers of up to 20 digits (digits and + signs).
This Device will try each telephone number 3 times before considering a call unsuccessful and quitting.
This Device will try each telephone number 3 times before considering a call unsuccessful and quitting.
,
,
,
,
,
The Contact ID Codes will be sent to the first number (with Contact ID reporting protocol) that answers the
call.
call.
Events description
Customer Code - type in a 4 character code (accepted values: digits and the letters A, B, C, D, E and F).
Event Code - type in the Contact ID to be transmitted when the respective event occurs.
Send - select (tick) the events to be sent.
Send over GPRS
If this option is enabled, the GS3055-I will only communicate Contact ID events via the GPRS network.
Periodic Reports
This Device can be programmed to send Periodic Contact ID reports. This section will allow you to select the Date and Time
of the first periodic report and the Interval between reports.
of the first periodic report and the Interval between reports.
GPRS Page
This page outlines the GPRS configuration options.
Access Point Name
Enter the Access Point Name of the GPRS service provider being used. (example: ibox.tim.it) Please contact the GPRS
service provider for this information.
service provider for this information.
Receiver IP address and Port
Enter the receiver IP address and the port number. Use the same as IP address and Port that is found in the 'Receiver Remote
Port' section of the WinBCS software or Sur-Gard SYSTEM III and SYSTEM II.
Port' section of the WinBCS software or Sur-Gard SYSTEM III and SYSTEM II.
APNs User Name and Password
Some providers may require a user name and password to validate communication. If needed, enter this information here.
Telephone numbers to decode
In this section you may enter up to two telephone numbers dialed by the panel that will be recognized by the GS3055-I when
called to trigger GPRS communication. If a number is programmed, any time a number dialed does not match one of the
phone number entered, the call will be routed through the voice channel. Leaving it blank will route all calls to GPRS.
called to trigger GPRS communication. If a number is programmed, any time a number dialed does not match one of the
phone number entered, the call will be routed through the voice channel. Leaving it blank will route all calls to GPRS.
SIM number
Enter the GPRS SIM number (optional)
DNIS
If required, enter the Dialled Number Identification Service number.
Account code
An account code is required for communication with WinBCS, Sur-Gard SYSTEM III or SYSTEM II receivers. Enter the
Account Code in this field.
Account Code in this field.
Calls Page
This page will allow you to view on the screen the Dialled, Received and Missed calls.
,
,
,
,
,
Each section can store a maximum of 10 calls. If the number of calls exceeds this limit, this Device will make
space automatically by deleting the oldest calls.
space automatically by deleting the oldest calls.