Digital Security Controls Ltd. 06PC5132 User Manual

8

If the RF5132-433 module does not show on the keypad, one of the following
conditions may be present:

• the module is not connected properly to the Keybus
• there is a problem with the Keybus wiring run
• the module does not have enough power
• no devices have been enrolled on the RF5132-433

NOTE: (for PC5010 v1.x control panels only) In order for wireless zones to be super-
vised, you must enable Double End of Line (DEOL) supervision in the PC5010 con-
trol panel. For more information, refer to your Installation Manual.

NOTE: (PC5020, PC1616, PC1864, PC501X, PC1555, PC580  v2.0 and higher only)
For wireless supervision to work, you must enable the wireless zone attribute on all
wireless zones (sections [101] to [132], option [8] ON).

Each wireless zone (WLS906-433,WLS904P-433 or WLS925L-433) will send a supervi-
sory signal every 64 minutes. If the receiver does not receive a signal within the time
programmed for the 

, it will generate a supervisory fault.

To program the wireless supervisory window:
1. Enter [*][8][Installer Code] to enter Installer Programming.
2. Enter [804] to enter the RF5132-433 Module Programming.
3. Enter section [81].
4. Enter the time period for the supervisory window. The window is programmed

in 15 minute increments. The default programming is 96 (x15minutes), which
is equal to 24 hours. Valid entries are (32) - (96), equal to 8 - 24 hours. 

5. To exit press [#].

NOTE: Supervision must be enabled for RF Delinquency.

All wireless zones have supervision enabled by default. To disable supervision for
any zone, enter the following at any system keypad:
1. Enter [*][8][Installer Code] to enter Installer Programming.
2. Enter [804] to enter the RF5132-433 Module Programming.
3. Enter sections [82], [83], [84] and [85]. Enable or disable supervision for

each wireless zone by turning each relevant option on or off.

4. To exit press [#].

For RF jamming detection to work, you must select an unused zone to be used as the
RF Jam Detect zone. When the receiver detects an attempt to jam the RF signal, the
RF Jam Detect zone will be violated and the system will generate a tamper signal.
When the jamming signal is gone, the RF Jam Detect zone closes and the system
sends a tamper restore signal.
To enable RF jamming detection:
1. Enter [*][8] [Installer’s Code].
2. Enter programming section [804].