Digital Security Controls Ltd. 06PC5132 User Manual

5

zone expander modules occupy zones in 2 groups of 4 (e.g. zones 9-12 and zones
13-16). None of the zones assigned to a PC5108 module may be used for wireless
devices. For more information on zone assignment, consult your system Installa-
tion Manual.

4. Enter the device ESN. The entry must be 6 digits.

5. The device is now enrolled on the system. Record the serial number and the

assigned zone number in the programming worksheets in the back of this
manual.

6. Continue with steps 3 - 5 until you have enrolled all wireless devices.
7. To exit press [#].

NOTE: The devices will not work properly until you complete zone and partition
programming (see section 4).

An electronic serial number (ESN) is printed on the back of each wireless key. ESNs
are used to enroll the wireless keys with the RF5132-433 receiver.
In order to reduce the occurrence of wireless keys with the same serial number, 6-
digit serial numbers are now printed on the back of each wireless key. The 6-digit
serial numbers include hexadecimal digits. For instructions on programming hexa-
decimal numbers, see your system 

Installation Manual, Section 4: How to Program.

NOTE: 6-digit serial numbers are only supported on the following control panels:
PC5020, PC1616, PC1864, P-8+, PC501X v2.0 & higher, P832/DL v2.0 and higher,
PC1555(MX), P-6B(MX), PC580/585 and P-48.

For wireless keys to work on the system, you need to enroll them and then program
the function buttons, if the default values are not the functions desired. Wireless keys
are not assigned to zones and require no zone programming. You can enroll up to
16 wireless keys on the system.

1. Enter [*][8][Installer’s Code] to go to the installer’s programming section.

2. Enter programming section [804].

3. Enter a 2-digit number [41]-[56] to program the wireless key serial number.

These numbers correspond to wireless key numbers 01- 16.

4. Enter the device ESN. The entry must be six digits.

5. The key is now enrolled on the system. Record the serial number and the

assigned slot number in the programming worksheets in the back of this manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.

7.

 By default, all

wireless keys are assigned to Partition 1. To assign keys to different
partition, see programming section [69].

: A wireless key can only be assigned to one partition.

8. To exit press [#].

(P)WLS919-433 and WS4939 wireless keys have four programmable function
buttons.  Default functions have been assigned, but you may program other functions