Digital Security Controls Ltd. 09GS260L User Manual
14
• Insert the previously activated SIM card face down in the SIM card holder.
2. Install the Communicator module into the Cabinet
NOTE: Before installing the TL260GS/GS2060 or inserting or removing the SIM card, ensure that the system is
turned off.
• Remove the cabinet’s front cover.
• Remove the circular knockout located in the top-right section of the panel. This knockout will be used for connection of the
• Remove the circular knockout located in the top-right section of the panel. This knockout will be used for connection of the
supplied antenna.
• Attach the 4-pin PC-Link cable connector to the panel board. Note that the red wire is on the left and the black wire is on the
right.
• Insert the Communicator into the panel.
• Locate the screw hole in the right hand wall of the panel. Line up the bracket and the side wall and, using the screw provided,
• Locate the screw hole in the right hand wall of the panel. Line up the bracket and the side wall and, using the screw provided,
affix the two together. Ensure that the threaded antenna connectijon point appears through the knockout hole of the cabinet.
• There are four terminals on the Communicator available for power connection, labeled PWR PWR GND GND.
• Attach either one of the two PWR terminals to the panel’s BELL+ terminal.
• Next, attach the other PWR terminal to the Bell; also, attach the panel’s BELL- terminal to the Bell.
• Next, attach the Communicator’s GND terminal to the panel’s AUX terminal.
• Finally, locate the 2-terminal block labeled GND SHLD. The SHLD terminal must be wired to the cabinet’s protective earth
• Attach either one of the two PWR terminals to the panel’s BELL+ terminal.
• Next, attach the other PWR terminal to the Bell; also, attach the panel’s BELL- terminal to the Bell.
• Next, attach the Communicator’s GND terminal to the panel’s AUX terminal.
• Finally, locate the 2-terminal block labeled GND SHLD. The SHLD terminal must be wired to the cabinet’s protective earth
ground (EGND).
• In the cabinet, locate the plug for the Ethernet cable and affix.
• Reassemble the PC1864 cabinet.
• Finally, attach the supplied antenna onto the antenna connector at the top right-hand side of the cabinet. Care must be taken
• Reassemble the PC1864 cabinet.
• Finally, attach the supplied antenna onto the antenna connector at the top right-hand side of the cabinet. Care must be taken
not to overtighten the antenna, as damage to the antenna may occur as a result.
NOTE: The installation procedure for the GS2060 is identical to the above, with the exception that it does not have
the Ethernet option.
3. Turn on the panel and check signal strength.
• Turn on the unit.
• The green LEDs on the Communicator board will indicate the signal strength. The right-hand green LED must be On and
• The green LEDs on the Communicator board will indicate the signal strength. The right-hand green LED must be On and
solid - not flashing - for the location to be acceptable. Please refer to STATUS LEDs on page 18 for more information.
DG009085D
G
00
90
85