Digital Security Controls Ltd. 09GS260L User Manual

24

Enter the Ethernet Gateway IP address of the dual communicator. The address must be entered as a dotted decimal number (e.g. 
192.168.1.100).  Each three-digit segment of the address must be within a valid range of 000 to 255.  The gateway is used in the 
event that the destination address is not on the local network. The data will need to be sent through a router device. This is the 
address of that router device.

When receiver supervision is enabled (Option 005, bit 1 and bit 2) the unit sends heartbeats to Ethernet Receiver 1 and GPRS 
Receiver 1 to indicate that it is still running. Use Option 004 to set the interval time at which heartbeats are sent. Receiver Supervi-
sion Interval window times are listed in the table below. 

The value you enter for Option 004 must be within the window time stated.

Jurisdiction

Window

UL CF

5min w/90sec heartbeats

UL CB

200sec

UL RF

30 days

UL RB

200 sec

ULC CB

180sec w/90sec heartbeats

ULC CF

180sec

Valid Data Range

Effect

Default

Bit 1

Ethernet Receiver 1 Supervised*

Disabled (Off)

Bit 2

GPRS Receiver 1 Supervised*

Disabled (Off)

Bit 3

Supervision Type:

On - Commercial Supervision

Off - Residential Supervision

Disabled (Off)

Bit 4

Primary Comms Channel - by default the primary path is Ethernet, then 

GPRS; this can be reversed by enabling bit 4

On - GSM

Off - Ethernet

Disabled (Off) 

- Ethernet 

Enabled (On) 

- GSM 

Bit 5

Redundant Communications - sends events at the same time over receivers 

1 and 3, 2 and 4 (Ethernet/GPRS)

Disabled (Off)

Bit 6

Remote Firmware Upgrade - via Ethernet 

Enabled (On)

Bit 7

UL Remote Firmware Upgrade - triggered by an onsite event

Disabled (Off)