Digital Security Controls Ltd. 163G4005 User Manual
4005 Series
25
Credit balance check
To find out the credit balance via SMS, you can either use the DLS 5 Console software (see section Programming via PC->Op-
tions->Pay As You Go), or you can find out remotely by sending an SMS message consisting of the characters “#CCC” followed
by the * character, in accordance with the following formula:
tions->Pay As You Go), or you can find out remotely by sending an SMS message consisting of the characters “#CCC” followed
by the * character, in accordance with the following formula:
#CCC*User PIN*
or for the Installer code:
#ICCC*Installer PIN*
The balance SMS will be sent to the Telephone Number of the sender.
The pre-paid SIM CARD credit management service may be suspended at any time, at the discretion of each individual GSM
network operator.
The pre-paid SIM CARD credit management service may be suspended at any time, at the discretion of each individual GSM
network operator.
Expiring Date Check
To know the expiring date of the SIM card via a SMS message remotely send a SMS message consisting of the characters “#EDC”
followed by the * character, in accordance with the following formula:
followed by the * character, in accordance with the following formula:
#EDC*User PIN*
The SMS with the expiring date will be sent to the Telephone Number of the sender.
Expiring Date Update
This command is used to update the information of the expiring date of the SIM card via a SMS message remotely send a SMS
message consisting of the characters “#EDU” followed by the * character, in accordance with the following formula:
message consisting of the characters “#EDU” followed by the * character, in accordance with the following formula:
#EDU*User PIN*new data*
The new date will be in the format: DD:MM:YYYY.
If the expiring date is disabled, when programmed by EDU the signalling is sent at 10:00am.If the expiring date is programmed by
DLS 5 (Option Page) than the hour and minutes will be reused when the date is update by EDU command.
DLS 5 (Option Page) than the hour and minutes will be reused when the date is update by EDU command.
Get Serial number
This command is used to get the serial number of the Communicator via a SMS message remotely send a SMS message consisting
of the characters “#RID” followed by the * character, in accordance with the following formula:
of the characters “#RID” followed by the * character, in accordance with the following formula:
#RID*User PIN*
or for the Installer code:
#IRID*Installer PIN*
The device will respond with: RID: 01234567.
Enable Installer
This command is used by the user in order to enable the Installer access, via a SMS message remotely send a SMS message
consisting of the characters “#ENI” followed by the * character, in accordance with the following formula:
consisting of the characters “#ENI” followed by the * character, in accordance with the following formula:
#ENI*User PIN*
An SMS feedback will be automatic sent to the sender in the event of success.
Disable Installer
This command is used by the user in order to disable the Installer access, via a SMS message remotely send a SMS message
consisting of the characters “#DSI” followed by the * character, in accordance with the following formula:
consisting of the characters “#DSI” followed by the * character, in accordance with the following formula:
#DSI*User PIN*