Digital Security Controls Ltd. 163G4005 User Manual
4005 Series
33
Enquiry Type: selection of enquiry type (none, SMS, Call, Service Command).
Enquiry Number: telephone number to call or to which an SMS message should be sent in order to request credit balance
information.
information.
Balance Message: string used to send SMS messages and to make requests via service commands.
Enquiry Interval: Enter the interval (HH-DD) at which you wish to send a periodic SMS containing credit balance information
(if supported by your telephone operator). The interval consists of the following values:
— (HH) next message time - Select the time at which you wish to send the next periodic SMS. The interval for these values
may be set between 0 and 23.
— (DD) next message day - Select the day on which you wish to send the next periodic SMS. The interval for these values
may be set between 0 and 365.
(if supported by your telephone operator). The interval consists of the following values:
— (HH) next message time - Select the time at which you wish to send the next periodic SMS. The interval for these values
may be set between 0 and 23.
— (DD) next message day - Select the day on which you wish to send the next periodic SMS. The interval for these values
may be set between 0 and 365.
SIM Expiration
SIM Expiration message: The SMS with the expiring information programmed by user and with the expiration date
appended will be sent to the first telephone number in phonebook.
appended will be sent to the first telephone number in phonebook.
The SMS is sent one time when the timeout expires only and no other attempts are performed.
SIM Expiration Date: fixed expiration date, the message will sent 30, 15, 7, 6, 5, 4, 3, 2 and 1 day before the expiry. Click on
the button NOW you set the current time of the PC.
the button NOW you set the current time of the PC.
Protocol Setting
Handshake Repetition: select the value: from 1 to 4.
Communication Protocol: select the type of protocol to be used: Contact ID or SIA.
According to the programming of the Communication Protocol option, the communicator is capable of decoding alternatively
events Contact ID or SIA events from the Control Panel connected on the line LI and can be the same for each telephone
number that the connected control panel calls.
The installer should verify that the operator (eg. Wind, TIM, Vodafone) work reliably with CID (Contact ID) over GSM, due to
problems in the quality of transmission.
events Contact ID or SIA events from the Control Panel connected on the line LI and can be the same for each telephone
number that the connected control panel calls.
The installer should verify that the operator (eg. Wind, TIM, Vodafone) work reliably with CID (Contact ID) over GSM, due to
problems in the quality of transmission.
Network Setting
This page is to start a session and / or remote programming:
Serial Number: enter the serial Number of the communicator.
Remote Access: check this box to enable remote programming.
Remote Access APN: access Point name, max 32 characters. This is an information which is generally required to the oper-
ator of the GPRS service. Enter the name of the service that provides the IP address.
ator of the GPRS service. Enter the name of the service that provides the IP address.
Remote Access User Name: some providers may require a user name to validate communication. If needed, enter this infor-
mation here.
mation here.
Remote Access Password: some providers may require a password to validate communication. If needed, enter this information
here.
here.
See paragraph “Enable or disable remote programming via SMS”.