Digital Security Controls Ltd. 163G4005 User Manual

See Figure 2 on page 3.

Jumper 21
j pins 1 and 2 connected, no input current limit (default);

k pins 2 and 3 connected, input current limit (450 mA, from battery charger side).
PST (Pass-Through)
J open, Pass-Through disabled (default);

K closed, the communicator will be able to perform remote programming of the PC 1864 4.1 EU, PC 1864 4.2 EU, PC 1864 4.2

ADT Spain and PC 1864 4.5 ADT Spain DSC Power Series intrusion panels, via cellular and PC-Link.

USB
The communicator, according to the jumper setting, from the USB point of view may be Host or Device:
J open, Device role (default);

K closed, Host role (see page 15).
TMP (Tamper):
J open, tamper detected (default);

K closed, tamper not detected.
UFC
Future Use

This Communicator manages SMS and Central Station transmissions and can simulate the land line in the event of trouble (land
line down) or even substitute the land line completely in areas where the GSM service is provided and where the land line is not
available. It has capability of communicating alarm signals via the GPRS data network. This capability enables a fast reliable path
to central stations equipped with a Sur-Gard System III or System II receiver.
The performance of this Communicator depends greatly on GSM Network coverage, therefore, it should not be mounted without
first performing placement tests of the antenna to determine the best location for reception (at least the LED   should remain lit).
The communicator has 6 T terminals that can be programmed as follows:
– Outputs (default setting) which can be activated/deactivated remotely, or used to provide status indications (problems on the
PSTN telephone line; problems on the GSM network; Supervision Message Missing; Fail To Communicate FTC), IP receiver fault,
Power fault, Tampers, Jamming detect, Antenna fault, Reserved output.
– Input: Panel interconnection Presence: used to be connected with a panel, Voice dialler: used to trigger a voice dialler event, SMS
dialler: used to trigger a SMS dialler event, Dialler Block: used to stop the dialler and delete the queue, Force Communication On
GSM: force the line switch from LE to LI, Internal CID/SIA: used to generate the internal CID/SIA event. This Communicator can
activate only as intended and cannot be used as a modem for fax/data transmissions or for teleservice operations.

The numbers in square brackets [  ] in this manual refer to the main parts of this Communicator (see Figure 1 and 2, and relative
table on page 2).