Digital Security Controls Ltd. 18LE2077 User Manual
11
I
NSTALLING
CAT 5 C
ABLE
(TL2553G
ONLY
)
A Category 5 (CAT 5) Ethernet cable must be
run from a source with Ethernet/Internet con-
nectivity to the Communicator module, inside
the Self Contained Wireless Control Panel cabi-
net. The Communicator end of the cable must
have an RJ-45 plug, which connects to the
Communicator’s RJ-45 jack. All requirements
for installation of CAT5 Ethernet cable must be
observed for correct operation of the Communi-
cator, including, but not limited to, the following:
• Do NOT strip off cable sheathing more than
run from a source with Ethernet/Internet con-
nectivity to the Communicator module, inside
the Self Contained Wireless Control Panel cabi-
net. The Communicator end of the cable must
have an RJ-45 plug, which connects to the
Communicator’s RJ-45 jack. All requirements
for installation of CAT5 Ethernet cable must be
observed for correct operation of the Communi-
cator, including, but not limited to, the following:
• Do NOT strip off cable sheathing more than
required for proper termination.
• Do NOT kink/knot cable.
• Do NOT crush cable with cable ties.
• Do NOT crush cable with cable ties.
• Do NOT untwist CAT5 pairs more than
1.2cm ( ”).
• Do NOT splice cable.
• Do NOT bend cable at right angles or make
• Do NOT bend cable at right angles or make
any other sharp bends.
NOTE: CAT5 specification requires that any cable bend must have a minimum 5 cm (2 in.) bend
radius. Maximum length of CAT 5 cable is 100m (328 ft.).
NOTE: The Ethernet cable shall not be visible when the installation is complete unless the install
NOTE: The Ethernet cable shall not be visible when the installation is complete unless the install
is a surface mount installation.
I
NSERTING
/R
EMOVING
THE
SIM C
ARD
1. Remove the front cover
of the SCW Control
Panel to access SIM
card holder.
Panel to access SIM
card holder.
2. Remove power from the
SCW and disconnect
the backup battery
connections.
the backup battery
connections.
3. On the SIM card holder push gently to slide the cover towards OPEN as indicated by the
arrow on SIM holder. This will unlatch the SIM card holder on the side furthest from edge of
the Communicator. See Figure 1.
the Communicator. See Figure 1.
4. Lift up the SIM card holder from the side that is not hinged.
NOTE: The SIM card can be damaged by bending or scratching contacts. Use caution when
NOTE: The SIM card can be damaged by bending or scratching contacts. Use caution when
handling the SIM card.
5. Insert or remove the SIM card, noting the orientation of the notches on the SIM card and the
5. Insert or remove the SIM card, noting the orientation of the notches on the SIM card and the
SIM card holder.
6. When inserting a SIM card, insert the card in the proper orientation and gently push the SIM
card holder down and slide the holder as indicated by the arrow on SIM holder, to LOCK.
7. Apply AC power to panel, and replace the panel cover.
NOTE: If two way audio is enabled you will NOT be able to swap the SIM card with another card.
NOTE: If two way audio is enabled you will NOT be able to swap the SIM card with another card.
RJ-45 Connector
DG0009635
Figure 2: RJ-45 Pinout
SIM Card Pinouts
DG0009396
Figure 3: SIM Card Pinouts