Digital Security Controls Ltd. 18LE2077 User Manual

C24 C

OMMUNICATIONS

™

CCOUNT

AND

SIM

CARD

CTIVATION

(Before Installation)
Installation of the Communicator requires activation with Connect24 before operation. Dealer
application forms and additional information on the Connect24 Voice Response Unit (VRU) and
graphical user interface (GUI) can be found at http://www.Connect24.com or by telephone at:
USA 1-888-251-7458 or CANADA 1-888-955-5583.

IMPORTANT: Prior to installing a LE2077 or TL2553G Communicator, contact your monitor-
ing station to determine if it is a master re-seller or visit http://www.Connect24.com to become
an authorized dealer. In either instance, you will require a Profile Number, Installer ID Number,
and an Installer Password. Perform the following pre installation:
1. Retrieve the installer account and password from the master reseller, or from Connect24

directly.

2. Connect your browser to the Connect 24 website at: http://www.Connect24.com or use

the mobile website m.connect24.com.

3. Log in to the Connect24 website using your installer account and password.
4. Perform the following steps in a Connect24 session to activate the SIM card and initialize

programming:

a. Navigate to the Initialize an account section.

b. Select Profile (This information will be provided by the master reseller or by Connect24).

c. Select Product Module.

d. Enter the SIM card number.

e. Click Next then enter in all relevant information as required.

f. Confirm all information is entered correctly before submitting.

5. Repeat Step 4 to program another SIM card (i.e. another Subscriber), or log out from

Connect24.

6. When you are at the physical installation site, the Communicator will automatically connect

and download its programming from Connect24 once the unit is initialized.

NOTE: Following initial installation, you can log in to the Connect24 website at any time to re-

configure the Communicator remotely, using the account created for this installation. For more

information, refer to the Connect24 website.
Before leaving the installation site, the Communicator TL2553G shall be connected via an

APPROVED (acceptable to the local authorities) Network Interface Device (NID) (e.g., for UL

Installations, U60950 listed NID). All wiring shall be performed according to the local electrical

codes.

NCRYPTION

The Communicator uses 128 Bit AES Encryption. Encryption can only be enabled from the
monitoring station receiver. Each receiver can independently have encryption enabled or dis-
abled. When encryption is enabled, the central station will configure the device to encrypt com-
munications the next time the Communicator module performs a communication to that
receiver.
NOTE: Packets will start being encrypted only after the next event is sent to that receiver, or if

the unit is restarted.

OMMUNICATOR

NSTALLATION

ONFIGURATION

1. Connect24, DSC, and DLS IV are Registered Trademarks of Tyco International Ltd. and its respective Companies. All