TransCore 05531 User Manual
Encompass 4/4800 Multiprotocol Reader System Guide
8-14
Reports
The Encompass 4/4800 Multiprotocol Reader can be configured to transmit presence
without tag reports and input status change reports. A presence without tag report is
transmitted in data mode only, and only if the system has a presence detector. This
report is sent if a presence is detected without the detection of a valid tag ID. See sec-
tions
without tag reports and input status change reports. A presence without tag report is
transmitted in data mode only, and only if the system has a presence detector. This
report is sent if a presence is detected without the detection of a valid tag ID. See sec-
tions
and
If configured with command #82N Select Input Status Change Report Option to
transmit input status change reports, the reader will transmit a message to the host
computer any time the inputs change state. Input status change reports are transmitted
in data mode only. Input status change reporting is disabled by default. See sections
transmit input status change reports, the reader will transmit a message to the host
computer any time the inputs change state. Input status change reports are transmitted
in data mode only. Input status change reporting is disabled by default. See sections
and
. Also refer to
for information on message formats.
To set presence reporting
1.
Ensure that the host computer is in command mode.
2.
Enter command #529 to display presence input status and press ENTER. P0
indicates presence without tag reports disabled (factory default), and P1 indicates
presence without tag reports enabled.
indicates presence without tag reports disabled (factory default), and P1 indicates
presence without tag reports enabled.
3.
Enter command #6901 to enable presence without tag reports, or enter
command #6900 to disable presence without tag reports (factory default). Press
ENTER
command #6900 to disable presence without tag reports (factory default). Press
ENTER
.
To set input status change reporting
1.
Ensure that the host computer is in command mode.
2.
Enter command #560 to display input status change report options and press
ENTER
ENTER
.
•
EO = input status change reports disabled (factory default)
•
E1 = input status change reports enabled
•
M0 = reporting disabled (factory default)
•
M1 = changes on input0 reported
•
M2 = changes on input1 reported
•
M3 = changes on either input reported
3.
Enter command #821 to report any change on input0, command #822 to report
any change on input 1, command #823 to report changes on input0 and input1,
or command #820 to disable status change reports (factory default). Press
ENTER
any change on input 1, command #823 to report changes on input0 and input1,
or command #820 to disable status change reports (factory default). Press
ENTER
.