TransCore 05531 User Manual
Installing the Encompass 4/4800 Multiprotocol Reader
4-5
•
Wire stripper
•
One Encompass 4/4800 Multiprotocol Reader-compatible antenna (if required)
•
Suitable RF interface coaxial cable (if using antenna)
Pre-installation Testing of the Encompass 4/4800 Multi-
protocol Reader
protocol Reader
Before installing the Encompass 4/4800 Multiprotocol Reader permanently at the site,
you should use an audible circuit tester to confirm that the Encompass 4/4800 Multi-
protocol Reader has power and can read a tag presented in the tag read zone.
you should use an audible circuit tester to confirm that the Encompass 4/4800 Multi-
protocol Reader has power and can read a tag presented in the tag read zone.
Testing the Encompass 4/4800 Multiprotocol
Reader Using an Audible Circuit Tester
Reader Using an Audible Circuit Tester
An audible circuit tester is also called a buzz box. These boxes are available at some
electronic parts supply stores, or you can make a buzz box, as shown in
electronic parts supply stores, or you can make a buzz box, as shown in
The buzz box is powered by a 9V DC battery and is equipped with two alligator-clip
leads. When you touch the leads together, the box makes an audible sound.
leads. When you touch the leads together, the box makes an audible sound.
Figure 4-1 Wiring for Audible Circuit Tester
To test the Encompass 4/4800 Multiprotocol Reader that uses an internal antenna,
connect the power supply as described in the appropriate section below, and then test
as described in the section
connect the power supply as described in the appropriate section below, and then test
as described in the section
To test the Encompass 4/4800 Multiprotocol Reader that uses an external antenna,
connect the antenna and connect the power supply as described in the appropriate sec-
tion below, and then test as described in the section
connect the antenna and connect the power supply as described in the appropriate sec-
tion below, and then test as described in the section
.