Codan Radio Communications VT-3-150-SN User Manual

Page of 262
VHF Amplifier Instruction Manual VT-3 132 - 174 MHz
3-3
3.6.2
VT-3/150 Amplifier Adjustment
The  Amplifier  alignment  consists  of  two adjustment  procedures;    (i)  a  general  set  up  (section
3.6.2.1) procedure which sets up the proper bias conditions for the RF  transistors and (ii) the RF
threshold adjustments  which  set  up  the  desired  alarm  threshold  levels  as  well  as  the  RF  output
power. The general alignment procedure is required following major repair operations, changes in
RF input levels or large changes in operating frequency (greater than ± 1.0 MHz).
The  RF  output  and  alarm  threshold  level  adjustments  are  more  easily  accessible  so  that  fine
adjustments can be  made in  the  field. Depending  on  user  requirements,  the  RF  alarm  threshold
levels should be checked  whenever  a  significant  change  in  operating  frequency (±  0.5  MHz)  is
made. As the antenna VSWR alarm is dependent on the output power alarm, the output power alarm
should always be set first.  The order of adjustment should be:
1)
Set the desired output power alarm level  (section 3.6.2.2).
2)
Set the output power  (section 3.6.2.3).
3)
Set the desired Antenna VSWR alarm level  (section 3.6.2.4).
4)
Set the desired overload condition level (section 3.6.2.5).
Details for the alignment steps are outlined below.
 3.6.2.1
General Set-Up
All  of  the  setup  steps  detailed  below  are  performed at  the  factory  as  part  of  the  initial
Transmitter  alignment.  A  general  realignment  of  the  Amplifier  Module  will  be  required
under the following conditions:
(i) the nominal RF input power applied to the amplifier is changed from that
which the amplifier was intially set up for, and
(ii)  components,  particularly  the  RF  transistors  Q1  and  Q2,  are  replaced
during a repair operation.
1.
Connect the transmitter's antenna output connector  to  the  type  N  input  of  the  radio
communications test set through a short section of low loss 50 
Ω
 coaxial cable.
2.
Turn  all four  (4)  of  the  adjustment  potentiometers  (R7, R21,  R36,  and  R37)  fully
counterclockwise.
3.
Turn on the power to the transmitter.