Data Critical Corporation 02DR-10100 User Manual
WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
106
PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
Setting Access Point Parameters
You can view and edit the settings for all Access Points on the network with the
Access Point Settings screen.
Access Point Settings screen.
To view and edit Access Point settings:
Note:
In order to view the Access Point button, the system must be designated as
the device master (see “Designating a Device Master” on page 103).
the device master (see “Designating a Device Master” on page 103).
1. Click the Access Point button on the OpenNet LAN screen to open the
Access Point Settings screen (fig. 62).
Fig. 62. Access Point Settings Screen
2. Click the Pg Up, Pg Dn, and arrow buttons to select each Access Point and
view its current settings.
3. Click the Edit button to open the Access Point Configuration screen (see
“Configuring Access Point Parameters” on page 108). This will allow you to
change the selected Access Point’s parameters.
change the selected Access Point’s parameters.
4. Click the Add AP button to open the Access Point Configuration screen and
configure the settings for the next available Access Point in sequence (see
“Configuring Access Point Parameters” on page 108).
“Configuring Access Point Parameters” on page 108).
5. Click the Remove button to remove a selected Access Point from the Access
Point Settings screen and the OpenNet LAN.
•
•
A warning popup will display requesting you to click either Yes, which will
remove the selected Access Point, or No, which will close the popup and
leave the Access Point unchanged.