Seiko Instruments AB000001 User Manual

- 

40

 - 

 

 

Follow the steps shown below to charge: 

(1) Connect a dedicated AC cable to the multi-battery charger. 

(2) Connect the AC cable to the AC adapter. 

(3) Put the AC cable plug into the inlet. 

(4) Mount the battery pack on the battery charger so that the electrodes of the battery pack can be 

aligned with the metallic terminals of the battery charger. 

(5) The CHARGE lamp on the battery charger lights red to start charging. 

(6) The CHARGE lamp changes to green when the battery is fully charged. 

(7) Remove the battery pack after charging is completed. 

(8) Unplug the AC cable from the inlet. 

 

 

Not connected 

Off 

During charging 

Red on 

Charge completion 

Green on 

Error Red 

blinks 

Hints 

•  If the CHARGE lamp does not light for a few minutes after start of charging, the battery 

pack is out of order. 

Stop using the battery pack. 

•  If an error is detected in the battery pack, the CHARGE lamp blinks. 

The error may be caused by going out of the battery life, so replace the battery pack 

with a new’s. 

•  The battery pack and the battery charger may be heated to a very slight extent during 

charging.  There is no problem. 

 

 WARNING 

♦  The AC adapter for the multi-battery charger differs from the one of the printer.  

DO NOT use the dedicated AC adapter for other devices. Doing so may cause a fire 

or an accident by an explotion, an ignition, or a generating heat.