Park Air Systems Limited B6350 User Manual
FITTING A RADIO INTO AN EQUIPMENT RACK
CAUTION!
It is essential that the chosen mechanical installation provides adequate support along
the depth (front to rear) of the unit. The transmitter must not be supported by the front
panel; doing so can cause damage.
the depth (front to rear) of the unit. The transmitter must not be supported by the front
panel; doing so can cause damage.
The transmitter can be installed on telescopic slides, or on fixed runners, within a standard 483 mm
(19 inch) equipment rack. M4 tapped holes, each 10 mm deep (see Fig. 1-11) are provided on each side
of the equipment to accept the slides. Details of suitable telescopic slides and fixed runners are available
from PAE.
(19 inch) equipment rack. M4 tapped holes, each 10 mm deep (see Fig. 1-11) are provided on each side
of the equipment to accept the slides. Details of suitable telescopic slides and fixed runners are available
from PAE.
When fitted in the rack, the transmitter's front panel must be secured to the racks chassis using four
M6 x 16 mm screws and plastic washers.
M6 x 16 mm screws and plastic washers.
CONNECTING REMOTE FACILITIES
Remote facilities connections depend on the transmitter's operating mode. To determine the required
remote connections, refer to chapter 3 of the section applicable to the operating mode.
remote connections, refer to chapter 3 of the section applicable to the operating mode.
T6T General Information
Section 1
Page 25
Fig. 1-11. Telescopic Slide Fixing Points
(DEV083-09)