Park Air Systems Limited B6350 User Manual
DC SUPPLY CONNECTION
The transmitter operates from either an ac, or a dc input supply. When both ac and dc are connected,
operation from the ac supply takes priority; automatic change-over to the dc supply occurs if the ac
supply fails. On restoration of the ac supply, the equipment reverts to ac operation.
operation from the ac supply takes priority; automatic change-over to the dc supply occurs if the ac
supply fails. On restoration of the ac supply, the equipment reverts to ac operation.
A dc input supply connector (see Fig. 1-5 on page 15) is fitted to the equipment's rear panel. The
recommended minimum rating of the dc supply cable is: 2-core having a cross-sectional area of 1.5 mm
recommended minimum rating of the dc supply cable is: 2-core having a cross-sectional area of 1.5 mm
2
per core. The supply cable should be fitted with an XLR3 connector (PAE part number 20-01030106).
CONNECTING AN ANTENNA
The antenna feeder cable connects to the transmitter’s rear panel N-type antenna connector (see
Fig. 1-3 on page 14).
Fig. 1-3 on page 14).
SWITCHING ON
When installation is complete, the transmitter should be switched on at the rear panel Power switch (see
page 14).
page 14).
T6T General Information
Section 1
Page 27