Digital Monitoring Products Inc PC0132 User Manual

For your convenience, an additional pre-printed serial number label is included. Prior to 

installing the device, record the serial number or place the pre-printed serial number 

label on the panel programming sheet. This number is required during programming.
The keypads can be programmed into the control panel by entering the serial number 

in Device Setup panel programming, or alternatively using the wireless keypad 

association operation. A maximum of 4 keypads may be used with the panel.

All DMP keypad housings are designed to easily install on any single-gang switch box 

or flat surface. Figure 9 shows the keypad housing base mounting hole locations.

The 9800 Series Wireless Graphic Touchscreen Keypads provide a built-in survey 

capability in the Installer Options menu to allow one person to confirm keypad 

communication with the panel. See Accessing Keypad Wireless Survey later in this 

document.

The keypad housing is made up of two parts: the cover, 

which contains the circuit board and components, and the 

base. Use the following steps to separate the keypad cover 

and base:

1. Insert a flat screwdriver into one of the slots on the 

bottom of the keypad and gently lift the screwdriver 

handle toward you while pulling the halves apart. 

Repeat with the other slot. See Figure 8.

2. Using your hands, gently separate the front from the 

base and set the cover and components aside.

9800

Series

Graphic

Keypad

Building Wall

Insert small 

screwdriver and 

lift to remove 

cover.  

Do not twist.

Figure 8: Removing the 

Keypad Cover