Digital Monitoring Products Inc PC0134 User Manual

LT

-1186  1.01 © 2011 Digital Monitoring P

roducts, Inc.

800-641-4282

www.dmp.com

Made in the USA

INTRUSION • FIRE • ACCESS • NETWORKS

2500 North Partnership Boulevard

Springfield, Missouri 65803-8877

11365

This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions:  

(1) This device may not cause harmful interference, and  

(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could void the 

user’s authority to operate the equipment.
NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of 

the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential 

installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no 

guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference 

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:
- 

Reorient or relocate the receiving antenna.

- 

Increase the separation between the equipment and receiver.

- 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- 

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Industry Canada Licence-exempt RSS standard(s).  Operation is subject to the following two conditions: 

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may 

cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation 

est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil 

doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Battery 

Life Expectancy  2 years  

   

 

(normal operation) 

3.0V Lithium 

CR123A 

See Battery Life Expectancy for full details.

Low battery  

Threshold signal  2.40V

Sensitivity 

2.3% ±0.8%

Frequency Range 

903 - 927 MHz

Dimensions 

Detector 

5.8” x 2.2”  

 

(14.3cm x 6.1cm)

Heat alarm specifications: 

Rate-of-rise 

15°F/min > 105°F  

 

(8.3°C/min > 40.6°C) 

Fixed  

135°F ± 5°F  

 

(57.2°C ± 2.8°C)

Drift compensation  

adjustment 

0.5%/ft. max.

Color 

White

1100D Wireless Receiver
1100DH Wireless High Power Receiver
1100DI Wireless In-line Receiver
1100X Wireless Receiver
1100XH Wireless High Power Receiver
XTL Panel with integrated wireless receiver
XT50 Series panel with integrated wireless receiver

U. S. Patent No. 7,239,236

FCC Part 15 Registration ID: CCKPC0134
IC Registration ID: 5251A-PC0134
Underwriters Laboratories (UL) Listed 

ANSI/UL 521  

Heat Detectors for Fire Protective  

 

   

Signaling Systems