Digital Monitoring Products Inc PC0159 User Manual

24

At the STOP prompt, pressing any Select key allows you to exit the programmer function

of the communicator. When selected, the communicator performs an internal reset and 

exits the programmer. The Stop function causes the following conditions to occur:

• The system is DISARMED 

• The communicator’s Status List is CLEARED

During the Stop function, all keypad displays are momentarily disabled for two seconds.

Afterwards, the programming function is terminated and the keypads return to the

Status List display.

Pressing COMMAND at the Stop prompt displays SET LOCKOUT CODE. This feature

allows you to program a special code that will then be required to gain access to the 

communicator’s internal Programmer through the keypad.

Changing the Lockout Code 

You can change this code at any time to any combination of numbers from 1 to 5 digits

long (1 to 65535). Do not use leading zeros for the lockout code.

1.  Press any Select key. The display changes to ENTER CODE: - .

2.   Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press

COMMAND.

3.   Enter the new Lockout Code again. Press COMMAND. The keypad display changes to

CODE CHANGED.

Once you have changed the code, it is important that you write it down and store it in

a safe place. Lost lockout codes require the communicator to be sent back into DMP

for repair. You may cancel a Lockout Code by entering 00000 at the Set Lockout Code

command prompt.

Lockout Code restriction:

Do not set a Lockout Code higher than 65535.

STOP

SET LOCKOUT CODE