Digital Monitoring Products Inc PC0181 User Manual

 

Activate Cell
Note: If the 265C Cellular Communicator has not been previously activated, Automatic Cellular Activation 

is performed when the panel powers up or is reset. 

Activate Cell (discussed below) is only necessary when 

Automatic Cellular Activation is not successful and communication was not established.
To begin the cellular activation for a 265C CDMA Cellular Communicator, verify that the 265C MEID has been 

added for the panel using Remote Link or by calling Customer Service (1-800-641-4282). At the keypad, press 

any select key when 

ACTIVATE CELL is displayed on the keypad. When the SURE NO YES? confirmation menu 

appears press the select key beneath YES to complete the cellular activation.

CELL ACTIVATED

NOT ACTIVATED

This option tests the signal strength of the selected SSID. Press any select key to 

display Wi-Fi signal strength. The

▐

’s represent the signal strength 0-7.

Good Signal (Excellent for consistent operation)

Average Signal (Expect consistent operation)

Weak Signal (Will not operate reliably. Relocate Wi-Fi 

equipment or add a Wi-Fi extender for better reception.)

This feature allows the installer to test XTLplus communication with Z-Wave 

devices. A successful test indicates a response from a device. Press any select key 

to view the Z-Wave Device List.
Press COMMAND to advance through each Z-Wave device and press any select key 

to begin the test on the device displayed.
The name of the device displays above the device number. The current number of 

successful communications followed by the total number of attempts displays to 

the right of the device number. The test stops after 99 attempts.
Press COMMAND to view the final number of successful communications.

Exiting the Diagnostics program
Press the COMMAND key until 

STOP displays. Press any select key. The keypad returns to the Status  

List display.

The XTLplus panel provides a walk test feature that allows a single technician to test all the protection 

devices connected to zones on the system. Conduct the Walk Test within 30 minutes of resetting the panel. 

The Walk Test automatically ends if no zones are tripped for 20 minutes. 

TEST IN PROGRESS displays at all 

keypads. When five minutes remain, 

TEST END WARNING displays. If any areas are armed the Walk Test does 

not start and 

SYSTEM ARMED displays.

To conduct the Walk Test, reset the control panel by pressing the RESET button 

then wait one minute. From the keypad, enter the code 8144. The keypad displays 

WALK TEST.
WLS (Wireless Check-in Test) - Select WLS to automatically test 1100 Series 

wireless transmitter communications. Includes all wireless devices except key fobs 

and transmitters programmed for a supervision time of 0 (zero).
PIR (Wireless PIR Walk Test) - The PIR Walk Test allows the installer to verify the 

1126 and 1127 operation. When enabled, the 1126 LED flashes each time motion is 

detected for up to 30 minutes. This is a local test only and no messages are sent to 

the Central Station.

 

SIGNAL

▐▐▐▐▐▐▐ 

HOMENET123

TEST ZWAVE
DEVICE LIST:
HALLWAY LIGHT

HALLWAY LIGHT
LIGHT 02 0/0

HALLWAY LIGHT
99/99 SUCCESSFUL

WALK TEST

STD WLS PIR