Digital Monitoring Products Inc PC0181 User Manual
XTLplus Installation and Programming Guide
Digital Monitoring Products
5
INSTALLATION
LED Operation
7.1 Backlit Logo
The backlit logo indicates the Power and Armed status of the panel. Depending on the operation, the LED
displays in Red or Green as listed in the table.
Color and Activity
Operation
Green Steady
Panel Disarmed, Primary Power OK, Battery OK
Green Blinking
Panel Disarmed, Primary Power OK, Battery Fault
No Light
Panel Disarmed, Primary Power Fault, Battery OK
Red Steady
Panel Armed, Primary Power OK, Battery OK
Red/Green Alternate
Panel Armed, Primary Power OK, Battery Fault
Red Blinking
Panel Armed, Primary Power Fault, Battery OK
RESET Button
8.1 Description
The RESET button is located on the top of the circuit board and is used to reset the XTLplus microprocessor.
To reset the panel prior to reprogramming, press the RESET button without powering down the system. After
resetting the panel, begin programming within 30 minutes. If you wait longer than 30 minutes, you must
reset the panel again. See Figure 5 for RESET button location.
TAMPER Button
9.1 Description
The tamper button is pressed when the cover of the XTLplus is secured onto the enclosure. When the cover
is removed, the XTLplus sends a Tamper Trouble message to the Central Station. See Figure 4 for TAMPER
button location.
PROG Programming Connection
10.1 Description
Onsite programming can be completed using an associated wireless keypad or by connecting a hardwired
keypad to the PROG header.
On-Board 1100 Series Wireless
11.1 Wireless Antenna
The XTLplus Wireless Antenna is integrated into the circuit board. The panel’s built-in wireless receiver
operates with DMP 1100 Series transmitters. See section 3.1 for a list of accessory devices.
11.2 Wireless LED Operation
The wireless LEDs are located in the upper right of the circuit board below
the RESET button and
function as follows:
Green: The green LED flashes every time the receiver transmits (32 times
Green: The green LED flashes every time the receiver transmits (32 times
per second). If the panel is reset, or the panel is powered off, the green
LED is off. Under normal operation, the green LED flashes constantly with no
interruption or change.
Yellow: The yellow LED flashes every time the panel receives a message from
Yellow: The yellow LED flashes every time the panel receives a message from
a programmed wireless transmitter. When a message is sent by a transmitter,
typically by pressing or releasing the TAMPER button, the yellow LED should
flash indicating that the panel received a message from the transmitter.
If the LED never flashes, the transmitter is not getting through to the panel. This could be because of a
misprogrammed serial number or the transmitter is too far away. Under normal operation, the yellow
LED flashes at every trip of every wireless transmitter and when the transmitters perform their periodic
check-in. It is not unusual for this LED to stay off for many minutes at a time when no transmitters are
communicating. See Figure 5 for Wireless LED locations.
RESET
LOAD
XTL PLUS
B
AT
PROG
R B
+ DC -
S
N
LEV
LPC-0181
R1
INSTALL GUIDE
LT-1434
LT-1434
CELL
MODULE
©
2015 DMP
WWW.DMP.COM
Red LED
Green LED
Green
Transmit
LED
Yellow
Receive
LED
WiFi
LED
TAMPER
Button
Figure 5: XTLplus Wireless
LED’s