UTC Fire & Security Americas Corporation Inc 759-ROR User Manual
3
Learn Mode Commercial Rate-of-Rise Heat Sensors Installation Instructions
Mounting the Sensor
Secure the sensor at its permanent location as follows:
1. Locate the base mounting holes (inner pair and outer pair) and mount the base to the wall or
ceiling with the appropriate hardware (see Figure 2).
Figure 2. Sensor and Base Mounting Hole Locations
2. Attach the sensor to the base.
Replacing
Batteries
Batteries
When the sensor battery gets low, the sensor transmits a low battery signal. The panel receives
this signal and sounds trouble beeps through system sirens. Pressing the STATUS button identi-
fies the sensor with the low battery.
this signal and sounds trouble beeps through system sirens. Pressing the STATUS button identi-
fies the sensor with the low battery.
Replace the battery immediately when this condition occurs, using only Saft LS 14250 C 3.6 volt
lithium battery.
lithium battery.
Battery Disposal
Batteries that are no longer usable are considered hazardous waste. Be sure to properly dispose of
the old batteries. Contact your local city government for hazardous waste disposal laws.
the old batteries. Contact your local city government for hazardous waste disposal laws.
Specifications
Compatibility: ............................ Commander 2000 and Custom Versions, CareTaker Plus and
Custom Versions, SX-V Special (software versions 8.0 and
later), Concord (software versions 3.0 and later), Concord
Express, Simon 2, Simon 3 (software versions 3.6 and later)
later), Concord (software versions 3.0 and later), Concord
Express, Simon 2, Simon 3 (software versions 3.6 and later)
Frequency: .................................. 319.5 MHz.
Power Requirements: ................. One Saft LS 14250 C 3.6 volt lithium battery
Operating Temperature Range: .. (60-926-01-95) 40° to 100°F /4° to 37°C
(60-926-95) 32° to 150°F / 0° to 66°C
Storage Temperature: ................. (60-926-01-95) -30° to 120°F / -34° to 48°C
(60-926-95) -30° to 140°F / -34° to 60°C
Maximum Humidity: .................. 90% relative humidity, non-condensing
Dimensions: ................................ 4.40” (11.18 cm) diameter
2.20” (5.59 cm) depth
FCC Notice
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device may not cause harmful interference.
• This device must accept any interference that may be received, including interference that may cause undesired opera-
tion.
Changes or modifications not expressly approved by GE Security can void the user’s authority to operate the equipment.
FCC ID: B4Z-759-ROR
Listings
UL 985 Household Fire Warning System Units (applied for)
UL 521 Heat Detectors for Fire Protective Signalling Systems (applied for)
UL 864 Commercial Fire Warning System Units (applied for)
UL 521 Heat Detectors for Fire Protective Signalling Systems (applied for)
UL 864 Commercial Fire Warning System Units (applied for)
Sensor Mounting Holes
Base Mounting Holes