User ManualTable of ContentsLearn Mode Commercial Rate- of-Rise Heat Sensors1Product Summary1Equipment Needed1Installation1Guidelines1Programming21. Separate the sensor from the base by twisting the sensor counter-clockwise and pulling it off the base. Set the base aside.22. Place the panel in program mode.23. Proceed to the LEARN SENSORS menu.24. When the panel prompts you for a sensor group number, enter the fire group number (26).25. Select the desired sensor number.26. When the panel prompts you to trip the sensor, press and release the tamper switch on the sensor (Figure 1). Sys tem sirens beep indicating successful programming.27. Exit program mode.2Figure 1. Tamper Switch Location2Testing21. Place the panel in the sensor test mode.22. Rub your hands together vigorously, until they feel hot.23. Place the palm of one hand on the round disc of the sensor, for about 7 to 10 seconds.24. Listen for the appropriate number of beeps from interior sirens and speakers (refer to the specific panel installation instructions).25. Exit sensor test.21. Plug in a portable hair dryer.22. Hold the hair dryer about 12 to 18 inches away from the sensor, aiming it at the side of the sensor.23. Listen for the appropriate number of beeps from interior sirens and speakers (refer to the specific panel installation instructions).24. Exit sensor test.2Mounting the Sensor31. Locate the base mounting holes (inner pair and outer pair) and mount the base to the wall or ceiling with the appropriate hardware (see Figure 2).3Figure 2. Sensor and Base Mounting Hole Locations32. Attach the sensor to the base.3Replacing Batteries3Battery Disposal3Specifications3FCC Notice3Listings3Document Number: 466-1941 Rev. A April 20041Size: 124 KBPages: 4Language: EnglishOpen manual
