UTC Fire & Security Americas Corporation Inc 984-PANIC User Manual
P/N 466-4431
• REV A.07 • Model No. • 21Aug13
1 / 5
Personal Panic Device Installation Sheet
Description
The water resistant Personal Panic
Device is a wireless device that can be
used to activate police or auxiliary
alarms throughout the premises. When
the help button is pressed, both red
LEDs flash and information is
transmitted. The transmitted signal
includes alarm and battery status
information. When the help button is
released, an alarm-restore-all message
is sent. Note: When pressing the help
button, wait until the red LEDs stop
flashing, then release the button.
The Personal Panic Device is shipped
with a watch type wristband installed. A
pendant adaptor kit and lanyard are
also included for an optional necklace
arrangement. The pendant kit includes
two plugs (shown below).
Installation
Assembly guidelines
•
Program the Personal Panic
Device into the appropriate panel
groups.
Device into the appropriate panel
groups.
•
The transmitter on the Personal
Panic Device has a maximum
range of 375 feet. Test the device
at the outer limits of the
installation. The outer limits may
vary due to different environments
that may affect the range.
Panic Device has a maximum
range of 375 feet. Test the device
at the outer limits of the
installation. The outer limits may
vary due to different environments
that may affect the range.
• Verify the user can activate the
help button by pressing it with their
thumb or finger.
thumb or finger.
•
When worn as a pendant, it is
important that the user does not
activate the help button by
pressing it against their chest. This
may reduce the signal’s effective
range.
important that the user does not
activate the help button by
pressing it against their chest. This
may reduce the signal’s effective
range.
Watch style wristband
Adjust the length of the wristband by
measuring and cutting the band in the
following manner:
1.
Position the wristband tightly
around the wrist and in the
intended position as shown in Step
2.
2.
Using a washable marker, place a
mark on the edge of each strap,
near the center of the wrist.
3. Align the band so the ends of the
band are even. Cut the band in the