UTC Fire & Security Americas Corporation Inc 984-PANIC User Manual
Personal Panic Device Installation Sheet
3 / 5
panel. Refer to the specific panel
Installation Instructions for further
detail.
1.
Set the panel to Program Mode.
2.
When prompted, enter the
appropriate group number and
select the desired sensor number.
appropriate group number and
select the desired sensor number.
3.
Press the help button on the
Personal Panic Device to trip the
selected sensor.
Personal Panic Device to trip the
selected sensor.
4.
Exit from Program Mode.
Maintenance and testing
Testing
Review the following for testing the
help button. Refer to the specific panel
Installation Instructions for further
detail.
1.
Set the panel to Sensor Test
Mode.
Mode.
2.
Press and hold the help button for
a second to monitor the beeps for
the packet count.
a second to monitor the beeps for
the packet count.
3. Listen for panel sirens. You should
hear 6 to 8 beeps.
4.
Test the help button from several
locations to ensure a consistent
response.
locations to ensure a consistent
response.
5.
Test the help button weekly to
ensure proper operation.
ensure proper operation.
Cleaning
1.
Gently rub a lanoline-based
cleaner, such as Go-Jo, onto all
surfaces of the Personal Panic
Device to remove any debris.
cleaner, such as Go-Jo, onto all
surfaces of the Personal Panic
Device to remove any debris.
2.
Rinse off using warm water.
3.
Wipe clean using a dry, lint-free
cloth.
cloth.
Replacing the battery
Caution: To avoid an alarm condition
you must set the panel to Sensor Test
Mode prior to changing the battery.
Caution: You must be free of static
electricity while handling the transmitter
circuit board. Touch a grounded metal
surface before touching the circuit
board.
1.
Remove the two screws on the
back of the Personal Panic Device
and observe how the pendant or
wristband components are
attached.
back of the Personal Panic Device
and observe how the pendant or
wristband components are
attached.
2.
Carefully separate the cover and
base.
base.
3. Remove the electronic sub
assembly from the base.
4.
Remove the battery from the
electronic sub assembly.
electronic sub assembly.
5.
Install the new battery. Observe
polarity.
polarity.
Note: Install Panasonic CR1632.
6.
Place the electronic sub assembly
into the base. Note: A generic
diagram is shown above. For
diagrams showing the wristband
and pendant configurations, see
the assembly diagrams in the
“Installation/Pendant” section.
into the base. Note: A generic
diagram is shown above. For
diagrams showing the wristband
and pendant configurations, see
the assembly diagrams in the
“Installation/Pendant” section.