Olympus Winter & Ibe GmbH ESG200 User Manual

42

System settings

The screen [Assign Foot Switch] is displayed.

2.  In the BIPOLAR pane of the screen tap the button for the required function, i.e. double 

pedal, only yellow pedal, only blue pedal or Autostart.

3.  In the MONOPOLAR pane tap the button for the required foot switch, i.e. double pedal, 

only yellow pedal or only blue pedal.

4.  Tap [Return] to confirm the settings.

The All Screen is displayed.

If the output power level is above 50 when selecting Autostart, then the output power level is 

reduced to 50 automatically.

Use this function to adjust the menu settings as summarized in the table “Overview of 

system settings” on page 39.

When opening the screen [Select Menu] there are 2 arrow buttons at the bottom.

1.  Tap [MENU] on the All Screen.

The screen [Select Menu] is displayed.

2.  Use the arrow buttons to browse back and forth between the pages of the screen [Select 

Menu].

For most of the following menu settings it is possible to interrupt the operation by tapping 

[Cancel] until the screen [Select Menu] is displayed again.

The delay for Autostart cannot be saved within a procedure setting.

Use this function to save all output settings that are currently displayed on the All Screen 

under a certain procedure name. In detail this is:

 - The bipolar modes for cutting and coagulation and their output levels.

 - The monopolar modes for cutting and coagulation and their output levels.

 - The assignment of the foot switch or Autostart for the bipolar mode SoftCoag.

It is possible to save up to 39 different procedure settings and to overwrite existing settings.

DRAFT 

– 

2017-01-17