Olympus Winter & Ibe GmbH ESG200 User Manual

41

System settings

To select one of the saved procedure settings proceed as follows:

1.  Tap [SELECT PROCEDURE] on the All Screen.

 - The screen [Select Procedure] is displayed with a list of saved procedure settings.

 - An already selected procedure is indicated by a highlighted button.

 - If no procedure settings are saved, the message [No procedure saved] is displayed.

 

• To return to the All Screen tap [Return].

2.  Tap the button of the procedure to be selected.

 - The All Screen is displayed which shows the settings of the selected procedure.

 - In the headline of the All Screen the name of the selected procedure is displayed.

Use this function to assign the double pedal foot switch either to the BIPOLAR output 

socket or to the MONOPOLAR output socket. It is also possible to assign one pedal of the 

foot switch to the BIPOLAR output socket and the other pedal to the MONOPOLAR output 

socket.

As a default setting the cutting modes for the BIPOLAR socket are switched off. Therefore, it 

is impossible to assign the yellow cut pedal to the BIPOLAR socket.

 

• To switch on the bipolar cutting modes refer to the section “Bipolar Cut Setup” on page 

46.

For the bipolar mode SoftCoag the feature Autostart can be assigned to the BIPOLAR 

output socket. Refer to the sections “Autostart for the bipolar mode SoftCoag” on page 22 

and “Autostart Setup” on page 45.

The chosen assignments are indicated by highlighted buttons. The figure above shows that 

Autostart is assigned to the BIPOLAR output socket. To the MONOPOLAR output socket, 

both pedals of the foot switch are assigned. If the foot switch is not connected properly, then 

no button is highlighted and it is impossible to assign the foot switch or Autostart.

To assign the foot switch or Autostart to the output sockets proceed as follows:

1.  Tap [FOOT SWITCH] on the All Screen.

DRAFT 

– 

2017-01-17